WHEEL OFFSET CALCULATOR
Compare your new wheel and tyre setup against the 70 Series factory specs. See exactly how much your wheels will poke or tuck, backspacing changes, track width difference, and whether it'll fit without modifications.
Poke / Tuck
--
mm per side
Track Width Change
--
mm total wider
New Backspacing
--
inches
Inner Clearance
--
mm change
Outer Clearance
--
mm change
SELECT YOUR SETUP BELOW
Choose your new wheel and tyre specs to see fitment results.
| Measurement | Stock | New Setup | Difference |
|---|
Factory Setup
New Wheel Setup
Negative = wheel pokes out | Positive = wheel tucks in
New Tyre Size
Suspension & Mods
Tyre Width Compatibility for Selected Rim
Based on your selected wheel width
Australian ADR Compliance Note
Tyres must not protrude past the bodywork/guards when viewed from above. If wheels poke past the guards, flares are required and must taper smoothly with no sharp edges. Overall vehicle width must not exceed 2.5m. Non-compliant setups may result in a defect notice. Always check your state's specific requirements.
Tyres must not protrude past the bodywork/guards when viewed from above. If wheels poke past the guards, flares are required and must taper smoothly with no sharp edges. Overall vehicle width must not exceed 2.5m. Non-compliant setups may result in a defect notice. Always check your state's specific requirements.
